Weber 32/36 Water Choke Adjustment

I have had the hardest time trying to figure out how to adjust the water choke on this thing. I know with the electric choke you kind of spin the plastic case around either direction for adjustment, but i've tried that with the water choke and its just not happenin.
I'm just wondering if there's something that I'm completely over looking or just have no idea about.

Also, if anyone has done a water to electronic choke swap and could explain how it is done I could just do that and skip the water choke.

Thanks.

The electric choke conversions just bolt right on in place of the water choke. The four (I think) screws that hold the choke assembly to the carb body come out and then you unhook it from the choke butterfly linkage and the fast idle linkage. Then screw the electric choke right on. You can buy the electric choke or take one off of another carb. I'll check when I get home, I might even have an electric choke carb hanging out...

Awesome, I've got an electric choke assembly from my old holley weber. I'll give that a shot and see how it fits on. I can't imagine it being too difficult to swap over. Sounds pretty simple.

The water choke is adjustable by turning as well. I think you just loosen the three screws around the sides that have the little tabs.

C|