PDA

View Full Version : My 1985 is MELTING!!!



hondajones
06-02-2016, 08:49 PM
My 1985 honda accord LX burnt out the neutral safety switch as well as the whole area under the shifter....it got really hot and melted the plastic...it made the shifter unable to switch gears. I replaced the neutral safety switch and it still gets hot. does anyone know the problem?

hondajones
06-02-2016, 09:23 PM
My 1985 honda accord LX burnt out the neutral safety switch as well as the whole area under the shifter....it got really hot and melted the plastic...it made the shifter unable to switch gears. I replaced the neutral safety switch and it still gets hot. does anyone know the problem?

conozo
06-03-2016, 03:14 AM
No electrical component should get so hot they melt things, make sure that all your fuses are the correct sizes.

I don't have any answer as to what is causing it though.

POS carb
06-03-2016, 12:24 PM
Your starter solenoid could be drawing too much power or the wiring between it and the starter is damaged and shorting...
Also on the 86-89 it powers the reverse lights so check that also

POS carb
06-04-2016, 05:30 AM
I thought I replied to this... Most likely causes:
1)Starter solenoid drawing two much current.
2)Reverse lights drawing too much current.
3)Short in one of the above circuits.

Have you noticed anything electrical quit working since this problem arose?

POS carb
06-04-2016, 05:42 AM
Sorry but this post made me think of this...
https://youtu.be/9TnGjq9mWSI#t=3m12s
Scroll to 3m12s for mobile users... :)

hondajones
06-09-2016, 02:47 PM
Your starter solenoid could be drawing too much power or the wiring between it and the starter is damaged and shorting...
Also on the 86-89 it powers the reverse lights so check that also

should I replace the starter solenoid and go from there?

POS carb
06-09-2016, 09:18 PM
You should check the current draw and replace parts accordingly.

Dr_Snooz
06-11-2016, 07:50 PM
Also look out for any corroded connectors that cause too much resistance and heat in the loom. I dab all connectors with dielectric grease to prevent corrosion. Physical damage to a loom can cause current to go places it shouldn't causing melting. Finally, if the heat shields for the exhaust system have disappeared, that can cause insulation in the loom to melt.

Dr_Snooz
06-11-2016, 07:58 PM
Merging dupe threads.