Temp guage not working....weber installed

[mcdaniel1138]

Hey guys. This is my first post other than the Newbie Introduction.
88 Accord Lx. Bought for $100. It was a steal as the car was clean.
She runs good, but the temp gauge is not working.
Initially I thought TSU.
But then someone posted something in the carb forum about installing a Weber and blocking off some things or rerouted coolant and that's what could cause the gauge to stop working. I don't have ANY coolant lines running to the manifold as far as I can tell.
The Weber was on the car when I bought it.
Any help would be great. Thanks.

[2ndGenGuy]

The temp gauge sender is either on the distributor housing, or it's on the back of the block. It should be a big, screw in sensor with one wire, IIRC. It might have just gotten knocked off.

[Griff]

The temp gauge sender is either on the distributor housing, or it's on the back of the block. It should be a big, screw in sensor with one wire, IIRC. It might have just gotten knocked off.

LXi is on thermostat housing LX and DX are on the back of the block.