InAccordance
08-05-2018, 07:05 PM
SOLD.
Now that the Dcoe setup is running good, it is time to sell off the 32/36
It is a genuine Weber 32/36 DGEV.
The E suffix means it is the electric choke version.
https://imgur.com/gallery/CYocHMp
Carb will need a rebuild kit thrown at it.
92-3237-05 - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=92-3237-05)
Will need a new air cleaner. The old one was getting pretty rusty and I didn't feel comfortable selling it. Needed a new filter anyway.
99217.332S - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=99217.332S)
Will need a linkage kit unless you use the piece I am including that allows the use of the kickdown cable on an auto trans.
99007.116 - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=99007.116)
You can find those cheaper most likely, I just used that site as a reference. Plus, I buy most of my carb stuff from them, highly recommended.
Does have a small leak around the throttle shaft. Has never been a huge deal and car ran just fine.
It's just dirty at this point. I've used it on two different Accords. Is jetted just about perfectly for the engine, good power and mpg stays as good as stock.
Adapter plates are good, not warped or cracked. Just dirty as well. They are aluminum so can just be washed if so desired.
I am missing one of the bottom plate mounting bolts so you will have to get that. Should be able to find one at a hardware store or a nut and bolt place.
The extras:
A base gasket, never used.
Two air cleaner clips still in good shape (Always keep spares)
The linkage I made to use the auto transmission kickdown cable if you want to install this on an auto.
Last piece is the thing I made that goes in the linkage to cause the secondary to open sooner than stock.
I will also thrown in some make-your-own gasket material.
I am looking to get $100 for everything shipped anywhere in the lower 48 states. Outside the lower 48, will have to charge shipping as it would be a bit more costly.
If you want me to rebuild the carb: $150
I will also help you in any way during installation. Any questions or problems, I will walk you though it.
Thanks!
Now that the Dcoe setup is running good, it is time to sell off the 32/36
It is a genuine Weber 32/36 DGEV.
The E suffix means it is the electric choke version.
https://imgur.com/gallery/CYocHMp
Carb will need a rebuild kit thrown at it.
92-3237-05 - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=92-3237-05)
Will need a new air cleaner. The old one was getting pretty rusty and I didn't feel comfortable selling it. Needed a new filter anyway.
99217.332S - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=99217.332S)
Will need a linkage kit unless you use the piece I am including that allows the use of the kickdown cable on an auto trans.
99007.116 - Carburetors Unlimited (http://www.carburetion.com/Products/ProductDetails.aspx?part=99007.116)
You can find those cheaper most likely, I just used that site as a reference. Plus, I buy most of my carb stuff from them, highly recommended.
Does have a small leak around the throttle shaft. Has never been a huge deal and car ran just fine.
It's just dirty at this point. I've used it on two different Accords. Is jetted just about perfectly for the engine, good power and mpg stays as good as stock.
Adapter plates are good, not warped or cracked. Just dirty as well. They are aluminum so can just be washed if so desired.
I am missing one of the bottom plate mounting bolts so you will have to get that. Should be able to find one at a hardware store or a nut and bolt place.
The extras:
A base gasket, never used.
Two air cleaner clips still in good shape (Always keep spares)
The linkage I made to use the auto transmission kickdown cable if you want to install this on an auto.
Last piece is the thing I made that goes in the linkage to cause the secondary to open sooner than stock.
I will also thrown in some make-your-own gasket material.
I am looking to get $100 for everything shipped anywhere in the lower 48 states. Outside the lower 48, will have to charge shipping as it would be a bit more costly.
If you want me to rebuild the carb: $150
I will also help you in any way during installation. Any questions or problems, I will walk you though it.
Thanks!