PDA

View Full Version : i broke the intake manifold?



johnwc723
02-21-2003, 05:57 AM
when i was replacing the o rings on my injectors, and i was screwing the rail back on to the manifold one of the screw things that comes off of it just broke off as i was tightening the bolt!!!

anyone got any ideas for this, do you think i need to try to fix it, or will the seal be alright without it?

it was this one:

g=good
b=broken

X X X X
g g b g

thanks!

AZmike
02-21-2003, 09:18 AM
I bet it works fine without it, but I'd keep an eye on it for the first few hundred miles to be sure. I saw an LXi manifold in marketplace if you're worried about it.

AccordEpicenter
02-21-2003, 06:05 PM
it should be ok unless there is a hole in the intake runner itself

johnwc723
02-22-2003, 01:17 AM
cool, thanks i hope its all good!!!

BoredRec
02-25-2003, 11:41 PM
It's fine, you didn't damage the manifold, and a thread extractor can get it out if it worries you in the future.

Johnny O
02-28-2003, 07:13 PM
Take out the broke stud and go to parts store or Honda and buy new stud.I would replace because their is alot of pressure in those injectors.

johnwc723
03-02-2003, 10:11 AM
yeah, maybe i should replae it! arrg, i havent noticed any problems yet though.

1988starter
04-03-2003, 07:37 PM
I think if you turn it wuth vicegrips the stud comes right out.