89 accord lxi steering knuckles

[G3n0c1d321]

Hey guys I have a question... I have been looking for both front driver and passenger steering knuckles. The unfortunate part is I can nor save the drivers side steering knuckle but can the passenger, the lower balljoint is pulling THROUGH the steering knuckle housing, yes down through the housing not up and out. I was.wondering if anyone can point me in the direction of new or used steering knuckles I would prefer new and the pair but if it comes down to just getting the driver side then so be it... I have been looking for weeks on google and not a damn thing, so please if anyone can help me out it would be much obliged

[Oldblueaccord]

Some acrua cars shared a similar knuckle that had the same upper and lower ball joint taper. Might help you widen your search in a junkyard. You are probably going to have to look out of state.

If it gets bad I think have a few old ones you can have.

[stat1K]

I wouldn't guess the knuckle would be damaged it is more likely the ball joint is collapsing and pulling through from being worn out. Have you measured the hole diameter for comparison? Pictures would help too...

[G3n0c1d321]

Yeah I have its.wallowed out allowing the balljoint to slip in the hole about a 1/8th inch so until I get another knuckle its.gonna.get redneckified and.welded in to just get me by for a.week or so hopefully I wont have a.catastrophic failure

[G3n0c1d321]

And on top of.all that the balljoint in it now are only a year old less.than 20000 miles on them

[G3n0c1d321]

Here are two images https://ibb.co/MprHW0R
https://ibb.co/MprHW0R

[G3n0c1d321]

https://ibb.co/hc07BmY

[Oldblueaccord]

https://www.ebay.com/i/153759696736?chn=ps&norover=1&mkevt=1&mkrid=711-117182-37290-0&mkcid=2&itemid=153759696736&targetid=882887725827&device=c&mktype=pla&googleloc=9013451&poi=&campaignid=6469750705&mkgroupid=89041169916&rlsatarget=pla-882887725827&abcId=1141176&merchantid=108712531&gclid=EAIaIQobChMI2Lyi4Obm6QIVCaCzCh1rygnsEAQYBCAB EgJLqPD_BwE#

Passenger with free shipping.

EDIT:


https://www.hondapartsnow.com/genuine/honda~knuckle~51210-se0-g31.html?Make=Honda&Model=Accord&Year=1988&Submodel=&Filter=(bt=2%2c72;et=2%2c3)&Location=pd:3454163,7

heres the Honda part number might be a better way to search for it.

Also here is what Moog list as Fitment
Front Lower Ball Joint moog-k9385 fits these vehicles:

Acura Integra 1990 thru 1993
Honda Accord 1986 thru 1989
Honda Civic 1988 thru 1991
Honda CRX 1988 thru 1991
Honda Prelude 1983 thru 1991