View Full Version : distributer cap !???
ACCORD EX
05-05-2003, 12:20 PM
i totally forgot about this but now i want to get right !
anyway !
i have an A20A2 engine with teh cap shown below ! when i ordered OEM wires from Majestic one of the wires didn't fit in! i checked teh part number and it 's right !
so i remembered then that i have a different distributer cap ! :(
anyway whn i checked both caps i found out the they will both bolt on ! but will thecap you guys use work on min e !??
i have a TEC distributer , carbed , manual !
the pics below will help you understand what i mean !
MIKE
ACCORD EX
05-05-2003, 12:21 PM
cap you guys have >
ACCORD EX
05-05-2003, 12:24 PM
my cap from inside !
DanG86LX
05-05-2003, 08:32 PM
I had the same problem with too shorter (new)wires for the straight prong cap. I ended up replacing my original dist with one from junkyard but with angled prongs.
I think u may use the angled prong cap on ur dist but.. there is a 90* diff between marking, like:
Wire No 1 goes to II
Wire No 3 goes to I
Wire No 4 goes to III
Wire No 2 goes to IIII
Hmm.. not sure, check urself again!
ACCORD EX
05-06-2003, 12:31 AM
i think you are right ! there is a 90* shift ! :(
well can i change the firing order ( to correct it ) in the new cap !?
are they identical from inside ?
thanx a lot man !
MIKE
DanG86LX
05-06-2003, 10:35 AM
"..are they identical from inside ?"
1. Well that's required! I mean the angle of the prongs with respect to the flat side.
2. With 1st cyl @ TDC, the dist tongue (rotor) points to ~ 1 o'clock on ur car and should touch a prong on both caps. That's the prong where u insert #1 wire. Then follow the firing order 1,3,4,2 as the tongue rotates clockwise. :smokin:
ACCORD EX
05-06-2003, 11:48 AM
i can just look at the leads from inside on both caps ! and then do a matching in firing order right ?
MIKE
DanG86LX
05-06-2003, 01:37 PM
Yah, that would work as well.
ACCORD EX
05-06-2003, 01:46 PM
thanx for the help DanG86LX ! i 'll see what i can do !
MIKE
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.