you 0-60mph time ( 0-100km )

[ACCORD EX]

how do you guys run it !
please state you shift at what rpm and what mods you have !

i am stock , shift at 4000 rpm , i got it in the 15's !

MIKE

[shepherd79]

according to G-tech i ran 9.8s,and it was before i put prelude distributor. i should be faster right now. i shifted at 6500.
my mods: header, straight pipe insted of catalitic converter, dynomax muffler,removed vacuum lines, accel coil and full tune up.

[AccordEpicenter]

my car was low 9s, stock lxi auto, low miles/minor weight reduction

[ACCORD EX]

damn i am slow ! gotto test shifiting at 5k or 6K ! :D
other input guys !?

MIKE

[AccordEpicenter]

my auto shifts at 6250

[3rd GEN]

mmmmmmmm not sure..but i gotta try.. i could prolly reach it in i'm just making a guess but maybe 8seconds or so..

I got full cat-back exhaust with Apexi N-1 muffler, ngk wires and plugs, short ram intake with K&N cone

[smufguy]

my lx, when it was carbed with a fucked up idle and bad thermo valve, i ran 10.8 seconds and that was when i shifted from 1 to 2 at 3k. I sure damn will test it out whith my Herbie2 this summer.

Sidenote: I did 9.84 sec with my 4g. and yeah its full auto and auto.

[Blue Impact]

15.2, driving normally. I shifted at around 2750 rpm (1st - 2nd), 2800 rpm (2nd - 3rd), 2900 rpm (3rd - 4th), and roughly 3000 (4th - 5th). My mods are shortram Matrix Civic intake pipe with APC filter and lots of stickers. :D

[ACCORD EX]

Originally posted by Blue Impact
15.2, driving normally. I shifted at around 2750 rpm (1st - 2nd), 2800 rpm (2nd - 3rd), 2900 rpm (3rd - 4th), and roughly 3000 (4th - 5th). My mods are shortram Matrix Civic intake pipe with APC filter and lots of stickers. :D

now i think i am not too slow ! :D

MIKE

[ACCORD EX]

any other times ??

MIKE

[Morpheus]

3 seconds when I drove off a cliff.

[Blue Impact]

Originally posted by Morpheus
3 seconds when I drove off a cliff.

Were you squeezing too? :D

[ACCORD EX]

Originally posted by Blue Impact
Were you squeezing too? :D

:lol !


MIKE

[smufguy]

i somehow managed to do 9.2 secs with my 4g tonight. I had my buddy use his gtech pro. Well, lets see what this auto 4g does with an intake and exhaust, better yet, we will see what my wonderful herbie2 will do in a matter of weeks.

[88accord]

i did it a while back it was like 7.8.pushing it as hard as it would go.

[smufguy]

7.8s is a sweet time. The quickest time i have seen a 3g do so far is Paul who did 8.8s i guess.

[ACCORD EX]

man those are some good times ! :)

MIKE

[SupaNam]

i roughly run at around 11 seconds.... it's a manual, stock car.... actually, i got a prelude ECU in there, but i don't think that should affect my rev limiter, nonetheless, i shift (when racing) at 7,000 rpms. i'm taking my car out to autoX next time it comes through my area. it'll be dope.

[smufguy]

if ur car is stock, ur power cuts off at 6500rpm or so once u hit the red line. Why would u still wanna shift at 7K?? it makes no sense unless u wanna put stress on ur motor and then blow it up.

[MIK3]

Hell if I know what my time is. Is there a thread on here or something that has all the stock 0-60 times? I'd like to know..

[Blue Impact]

Originally posted by MIK3_DX_STYLE
Hell if I know what my time is. Is there a thread on here or something that has all the stock 0-60 times? I'd like to know..

Condition of car and age will definitely not give you a time as good as when the car was tested new. I'm only speaking stock for stock.

[HondaBoy]

the best time i ever ran a 0-60 was about 9.6 sec. and it does depend on when i let it shift. if i take it up to the redline, it does worse. unfortuatly i dont have a rev limiter. guess thats not always a bad thing. but if i shift by hand, it dosent do as good as if i let it go by itself. its auto. the worst time ive timed was a bit over 10 sec. need to try it out again since ive replaced the wires and got it running fairly good.

[MIK3]

What would you guys say I do? I have never tested. But I'm running all stock other than a K&N Filter, mint condition DX, automatic, 1988 4dr. Sedan.

[smufguy]

around 10s defenitely or even in the 9s. oh u an automatic? i dont really know :D

[87AccordsterLx]

We did 3 different runs and took the average. I have a rebuilt (overhauled) engine, rebuilt tranny, rebuilt carb. flipped air cleaner lid, removed vac lines, 2.25in headers back piping with no cat. no res. dynomax Super Turbo exhaust. Individual parts were tweaked to help performance throughout the engine. I have the Enkei CDR9 rims that you see in the pic and Kumho Ecsta Surpa 712's. My average time was 8.7 but I pulled a 8.6 If can remember correctly. That’s one thing that I love about my 3g, the acceleration is incredible for these cars. I raced my buddy's 02 lude (h22) and I had him on the launch and through second. Then you can guess what happened... I got roasted. I was so excited though. Once I get the cam regrind and headers I think my modding will be complete. BTW it's an auto. Thank God for the tranny rebuild. If I let into her all the way she shifts a 6100 in every gear and on the open road she stops at around 5500 rpms in 4th and will max out at 122mph.

[SupaNam]

yea.... our 3geez are amazing in first and second haha. there's gotta be a way to hold that power throughout atleast one more gear! i raced my friend's BMW 5-series. and i hung with him thru first and second gear, but then got smoked too. nonetheless, he was pissed that i was able to hang for that long. my second gear runs up to about 60mph. and max out is about 117mph. no mods, except for a flipped carb lid.

[87AccordsterLx]

Sounds like she is in good shape man. Keep her maintained and she will love you forever! :)

[smufguy]

second gear ratio sucks on a 3g.

1st gear : 3.181
2nd gear: 1.842
3rd gear: 1.250

The second gear ratio should be in the 2s if u ask me.

[ACCORD EX]

that's why it sucks when shifting from 1st to second ! now i get it ! that's why i get good response from 2nd to 3rd ! :)

MIKE

[smufguy]

hahaha, u always learn new things everyday huh mike? :D

[MIK3]

Oh yeah. Forgot to mention that I have a flipped airlid if that makes any difference at all. Haha. When flooring it...it seems that first sticks forever. I need to let go of the gas for a little bit just so it doesn't redline...haha. I've never redlined yet...not going to take my chances with a 16 year old car, althought it is in mint condition. Heh. The latest the auto tranny has ever shifted from 1st to 2nd is 5200rpm. And I plan to go no further. Damn, 60 in 2nd is crazy. I've gotten up to 50 once...in an automatic, mind you...heh. Me running in the high 9's...that's crazy, but cool! Heh.

[ACCORD EX]

Originally posted by smufguy
hahaha, u always learn new things everyday huh mike? :D

yeah ! that's what i love about this board ! :)

MIKE

[smufguy]

ur da man mike. Tested out ur car again for the 0-60?

[krott5333]

hmmm.. cant we just do a regear, kinda like when mustang owners all get a 4.10...

sons of bitches

[ACCORD EX]

Originally posted by smufguy
ur da man mike. Tested out ur car again for the 0-60?

not yet ! but i'll sure will !

MIKE