wannaswapab20
08-01-2003, 07:08 PM
any of u guys kno the bore size of the a20a3? and by any chance u guys kno if the et2 head will bolt on the a20a3?? thanks guys
89LxiAg
08-01-2003, 09:08 PM
1987 A20A3: 3.25 inches x 3.58 inches (bore x stroke)
1988 A20A3: 3.25 inches x 3.58 inches (bore x stroke)
1989 A20A3: 3.26 inches x 3.58 inches (bore x stroke)
Hope this helps.
The ET2 from 1985 and 1986 both ran at 9.1:1 compression ratio, which is greater than the 1987 A20A3 8.8:1 compression, but lower than the 1988 and 1989 A20A3 compression ratios of 9.3:1. I don't think that makes any difference, but since the manual was open to that page I thought I'd pass it along.
Later.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.