Distributor question

[Zennik]

I've got an A20A3 engine from an '88 LXi that im putting in my '89 SE-i since the old motor took a crap.

Now my friend that was helping me is a retard and pulled all the plug wires off the old engine before I could write down what wire went where. Could someone tell me what the order is?

for ease of matching, the plugs are, from left to right, 4-3-2-1
and from top to bottom, the distributor is A-B-C-D

Can someone help me match it all up?

[2old_honda]

my dist from top to bottom goes 4-2-1-3

[Zennik]

Originally posted by 2old_honda
my dist from top to bottom goes 4-2-1-3



hmm, i'll try that, then, for some reason my distributor has no labelling on it, and its really made finishing this engine swap difficult

[deadlight]

One trick you can try, your distributor should have little lines around each hook up for your plug wires, 1 for cylinder 1, 2 for cylinder 2, etc. that's what I did, it's alot easier than having to look it up