View Full Version : hub nut removal
zippoz
10-22-2003, 12:56 PM
i am doing an engine swap on an 89 accord, and while going to remove the hubnuts, i came across a problem. the nuts were bent into the post, so that the not could not spin off, how do i go about removing this nut?
Vinny
10-22-2003, 12:59 PM
gonna have to raise the tab, might try using a chisel to beat it up out of the groove
shepherd79
10-22-2003, 02:02 PM
or you can use impact wrench.
k-roy
10-22-2003, 02:10 PM
You are supposed to do bend the hubnut in with a flathead and a hammer so it does not come off over time. That is a non reusable part. Mine was frozen in place. The dealship mechanic hooked me up, he had to use an assetling torch and an impact wrench to get that bitch off. You can try putting a pipe over the end of the wrench. I managed to break four craftsmen 1/2 drive wrenches that way. It worked on the other side though.
NXRacer
10-22-2003, 02:46 PM
I just used an impact on it and it came off after a little hammering on. who says its not a reusable part? I reuse em all the time......
k-roy
10-22-2003, 02:48 PM
Originally posted by NXRacer
I just used an impact on it and it came off after a little hammering on. who says its not a reusable part? I reuse em all the time......
According to the Honda Factory manual they should be replaced. I usually follow what the manufacturer reccomends.
Vinny
10-22-2003, 02:51 PM
they usually come with them, or atleast the 2 I bought and took back did
zippoz
10-26-2003, 11:54 PM
these cars are a pain in my ass, im just parting them out to save myself more problems and herat ache, so if you need parts pm me!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.