accordlxi2.0
11-14-2003, 07:08 PM
okay what i did now as for the fast idle was connect a vac line to the Fast Idle Unloader.
i used the blue thermovavle and i put it in the thermostat housing where the other thermosensor was.
i wait until it got cold then started it up.
it idled @ 1800rpm:) .
then 30sec. later it went down , then sputtered.
now it disegage too early, cause the intake need's to be a little warm.
so the thermosensor thet was in the thermostat housing what was the temp. opening for that?
what's the temp opening for the blue thermosensor?
any help is appriciated.
i used the blue thermovavle and i put it in the thermostat housing where the other thermosensor was.
i wait until it got cold then started it up.
it idled @ 1800rpm:) .
then 30sec. later it went down , then sputtered.
now it disegage too early, cause the intake need's to be a little warm.
so the thermosensor thet was in the thermostat housing what was the temp. opening for that?
what's the temp opening for the blue thermosensor?
any help is appriciated.