McNick
12-26-2003, 07:28 AM
Hi All!
My all 4 brake calipers are bouncing because of (sliding pin)-to-(caliper brackets) surface is weared and pin playing inside of bracket hole in all directions. Bouncing is not critical but this IMHO is wery dengerous!
Normally I can replace the pins but what I have to do with weared brackets?!
The local H-dealer dont sell brackets in separate. Only with caliper for about $300.
AEM big brake kit is also too expencive.
J/Y offer only calipers with the same bracket condition.
So what i have to do with this?
Do we have any aftermarket alternative for brackets?
Or rebuilding?
Or I have to use bracket(or whole caliper) for newest H-cars, which can be found on J/Y?
So! Dear 3geez community! What is the right solution?
This short message in my EnGliSh (sorry) was hard to write for me! :)
So please dont leave my work without your attention!
Tnx.
My all 4 brake calipers are bouncing because of (sliding pin)-to-(caliper brackets) surface is weared and pin playing inside of bracket hole in all directions. Bouncing is not critical but this IMHO is wery dengerous!
Normally I can replace the pins but what I have to do with weared brackets?!
The local H-dealer dont sell brackets in separate. Only with caliper for about $300.
AEM big brake kit is also too expencive.
J/Y offer only calipers with the same bracket condition.
So what i have to do with this?
Do we have any aftermarket alternative for brackets?
Or rebuilding?
Or I have to use bracket(or whole caliper) for newest H-cars, which can be found on J/Y?
So! Dear 3geez community! What is the right solution?
This short message in my EnGliSh (sorry) was hard to write for me! :)
So please dont leave my work without your attention!
Tnx.