Should I or not?

[L3G10N]

Look at this ugly manifold for A20A and weber...... should i buy it?

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2452921701&category=36474

[Elijah]

I would say bid $50 and if someone go's higher then let them have it.

[Vinny]

I think he sold some stuff in the marketplace at one time, actually I think he sold the carbs off that manifold. Looks kinda warped, maybe it just the angle or something. I guess 50-75 bucks wouldn't be too bad

[Dibbs]

I'd buy the damn thing just to use as a template to make myself a new one. Guy must have been on his 20th cup of coffee when fabbing this monster. It looks level where it counts but some of those welds spots look shotty. You can just tell he arced a few times by the splatter specs around the tubing and there's a couple of weld spots that look a bit underdone which could lead to problems down the road. I still think it's a good buy though. I'd slap it on my car in a minute, after I took measurements off of it and had a better quality manifold made.

[dXsquared]

it doesnt have the TILT needed for the carbs... 15 degrees or somthing.. anyway, cut the flanges off and make em flat... then get some new tube and set the angles...

Travis

[NXRacer]

or just save yourself the hassle and fab up your own. After all that work it would take to fix it you could make your own.

i wouldnt get that thing. Its pretty ghetto.

[PsychoPaul]

"For off-road use only, unless you "know" an inspector! Good luck!"
uhhh YEAH I KNOW ONE pfff doesn't everybody!!!!!!!!!