O2 sensor wire

[Magny]

Guys, I am trying to find the wire on this computer that is to the O2 sensor so I can hook up my Air/Fuel gauge. I don't know which one it is. I tried following the wire in the engine bay, but it goes into a cover so can't go far. I don't want to run a long wire to the engine bay just to lock it up, I want to make the wire as short as possible without making it travel so far to get a reading.

LOL it's hard to sing to Linkin Park while typing, it sucks. LP is coming here in San Jose on the 16th, hella want to go, but no tickets, hope they have some avalible when I get to the box office. It's $95 to get in. Damn it LOL. Hella want to go, never been to a Concert.

[A20A1]

look at pauls shop manual maybe... or shave off a bit of the wire loom that covers the wire set and match the wire colors.

it goes thru the passenger or drivers side fender... I forget. You might want to remove the fender and follow it into the car.

[Magny]

I checked the colors and tried to do color matching like you suggested, that don't work either. they are 2 different colors. the one in the engine bay is black with a brown line and red dots, the comp doesn't show it. I just got through installing my stereo again by sound. none of the wires for the stereo were the same either. had to figure out which one was pos and which one was neg. i wanted the speakers to push not pull. more sound quality and pressure pushing than pulling. (i know by exp.)

[Magny]

Well I finally gave up looking for it at the comp, so I just stripped the wire next to the sensor back and soldered it to there instead.