gauges (PAUL)

[dXsquared]

just threw my gauges in... they look sooo tight...

oh yah.. did a little modding... can you tell where??

http://www.imagestation.com/picture/sraid103/p34dffa65b97fbde90a4266bce09a8523/f9a7c80c.jpg


does anyone know if the screw at the bottom o the pic, on the left is the tach signal wire? its says tach on it, and its right behind the tach... i also found every hookup for my tach to make it full functional without stickin any wires through the firewall...

http://www.imagestation.com/picture/sraid103/p98ada3fc0425d13aa986378908a07169/f9a7c7ff.jpg

anyway, some one confirm the pic and lemme know

Travis

[k-roy]

That is probaly the tach wire going to the coil. Use a voltmeter to see if it has continuity to make sure it is the positive. I assume you are going to use a aftermarket tach?

The gauges look good, I see you added the "H" logo.
What paper did you use?

[dXsquared]

its 58lb photo paper... the light still shined through, so i just took the bulbs out the back.. who needs to see the mileage at night anyway?? the front lights make them look great

Travis

[i.c.]

did you use photoshop to print them out...when size are they to get lined up?

[dXsquared]

i just redownloaded them off pauls site.. went to print preview and they were perfect...

Travis

[i.c.]

really? when i opened them up the speedo came out smaller than the others

[johnwc723]

was that gauge setup hard to get out? im thinking of getting some inverted blues

[dXsquared]

not hard at all... it took me 5 minutes to pull the cluster and about 30-40 minutes to put the faces on.. i took my sweet time... most time was waiting for the flat black needles to dry

Travis

[lightbulblxi]

lookin good man!