P|eszczoH
05-23-2004, 02:39 PM
hi. few days ago I had a problem with my day lo beam in my aero.
My position lights were just fine, while the low beam didnt light a thing.
I thought that I'll have to change all the switch asembly at the stering column, but first I thought I will dispart this switch asembly.
To do it weve got to take of the stering wheel, all the plastic around,
than take of the left stick all the asembly of the stering column and than take the half that is responsible for position lights, low and high beam, and even turn signals from behind of whole asembly.
It was right move. what I have found was dirt, and this green stuff - I dont know the word in english, also there were lots of smoked plastic couse of high temp.. I dispart all the asembly , cleaned it, greased, and so on and what can I say. My lights work just great, and I think that my low beam is much brighter right now...
For all of You I think it is good to look at this after all these years that our 3g all have.
My position lights were just fine, while the low beam didnt light a thing.
I thought that I'll have to change all the switch asembly at the stering column, but first I thought I will dispart this switch asembly.
To do it weve got to take of the stering wheel, all the plastic around,
than take of the left stick all the asembly of the stering column and than take the half that is responsible for position lights, low and high beam, and even turn signals from behind of whole asembly.
It was right move. what I have found was dirt, and this green stuff - I dont know the word in english, also there were lots of smoked plastic couse of high temp.. I dispart all the asembly , cleaned it, greased, and so on and what can I say. My lights work just great, and I think that my low beam is much brighter right now...
For all of You I think it is good to look at this after all these years that our 3g all have.