Vinny
05-29-2004, 02:16 PM
Well it just goes to show that nothings impossible. I emailed over 30 places about DC strut bars and well........ here it is
http://www.photohost.org/gallery/data/500/1861strut_bar_box.jpg
http://www.photohost.org/gallery/data/500/1861P5290109.JPG
Yeah yeah I know I need to clean up the under the hood. Tomorrow I plan on bead blasting my spare valve cover for either polishing or powder coating. I also need to change a scrader valve and top off the r12 :D
http://www.photohost.org/gallery/data/500/1861P5290112.JPG
http://www.photohost.org/gallery/data/500/1861P5290111.JPG
And while I was there i took the Grinder to my bumper so I could FINALLY get the Erebuni bumper cover on. Its just a temp job for now, I took a little too much material off the hatch bumper and I'm missing some moutning hardware :dunno: Anyways here it is
http://www.photohost.org/gallery/data/500/1861P5290110.JPG
http://www.photohost.org/gallery/data/500/1861hatch1.jpg
And yes Dennis those are screws.......Its temporary. And YES I plan on taking the die grinder back to it and taking the center section out when I get the chance :D
http://www.photohost.org/gallery/data/500/1861strut_bar_box.jpg
http://www.photohost.org/gallery/data/500/1861P5290109.JPG
Yeah yeah I know I need to clean up the under the hood. Tomorrow I plan on bead blasting my spare valve cover for either polishing or powder coating. I also need to change a scrader valve and top off the r12 :D
http://www.photohost.org/gallery/data/500/1861P5290112.JPG
http://www.photohost.org/gallery/data/500/1861P5290111.JPG
And while I was there i took the Grinder to my bumper so I could FINALLY get the Erebuni bumper cover on. Its just a temp job for now, I took a little too much material off the hatch bumper and I'm missing some moutning hardware :dunno: Anyways here it is
http://www.photohost.org/gallery/data/500/1861P5290110.JPG
http://www.photohost.org/gallery/data/500/1861hatch1.jpg
And yes Dennis those are screws.......Its temporary. And YES I plan on taking the die grinder back to it and taking the center section out when I get the chance :D