i want to change all of my Exhaust system

[1988_5spd_lxi]

do any body know the price for a universal straight through muffler. 2/5 or 3' pipe from the exhust manifold to the muffler. maybe headers.

i got holes all over my exhust system so i want to change the whole thing. maybe not the headers too expensive. what is a cheap way to do my pipi over with some perfomance.

[Elijah]

I would only go 2 1/4 if you are N/A.And well you only have one header.And you can go with DC or pacesetter

[FatDave]

i have 2 1/4 from the manifold back, no cat, and a "cherry bomb" glass pack thats been washed, anything over that is overkill, you gotta have alittle back pressure, my system was done by my brother-in-law so it was at shop cost, i picked up some power, not much, i noticed the biggest gain when i installed the accel coil, platnium plugs and home-made CAI, all those working together i have seemed to have picked up 15hp, as elijah said, since the car isnt a turbo you dont need 2.5 or 3 inch, save your money go with a 2 1/4 inch from the cat back and a universal "import" muffler and forget the header for now and spend $60 on a accel super stock coil, parts to make the CAI, plugs,and wires but thats my opinion

[SteveDX89]

As stated, 2.25" is best. However, you exhaust is limited by the smallest diameter of pipe you have. So if you have the stock exhaust manifold, flex pipe, and cat, you won't gain much. 5 hp if you're lucky. A header back exhaust system is an excellent way to gain some power. Just make sure you replace the stock cat with a high flow or if you live a state that doesn't have emissions, take it out all together.

[FatDave]

my flex is a 2.25, and we have emissions here so near december i'll have to clamp the cat back in for the testing, then remove and weld a pipe back in :rolleyes:

[1988_5spd_lxi]

did any body bought this http://129.33.208.36/LPSCatBackExhaust.jpg
how was the installment how does it sound.


http://www.nopionline.com/nopistore/dsp_part_detail.cfm?vmakeid=140&vmodelid=010&vcatyear=1989&vnopinum=001%2B0561&vTitle=HONDA%20Accord%201989

[A20A1]

I'd say get an exhaust shop to do it, cause they use a decent metal that resists rusting. Aluminized I believe.

[SteveDX89]

did any body bought this http://129.33.208.36/LPSCatBackExhaust.jpg
how was the installment how does it sound.


http://www.nopionline.com/nopistore/dsp_part_detail.cfm?vmakeid=140&vmodelid=010&vcatyear=1989&vnopinum=001%2B0561&vTitle=HONDA%20Accord%201989

I have that. However, I don't have the muffler. I cut it off and used a Dynomax Super Turbo muffler and a Bosal tip. Make sure you strip the black paint off and re-paint it with high temperature paint though.

[Ludi Mali]

definately go to a muffler shop, I know theres one around here that will do a full custom exhaust for 150.