NEED PICS: racing seat mounts

[hondamanlxi]

i know sparco and momo make slider adapters but i have a set of DAD seats and i know some have made custom brackets! Anyone got pics of their mounts? Ive searched, but no thread lead to pics :stupid:

[hondamanlxi]

20 views and no answers...

[guaynabo89]

I used the stock brackets and weldade tabs and spacer to fit the seats.
Gonna see if I can get you pics in the next couple of days

[A20A1]

Here is the first ( Front ) part of the sliding bracket... it does slide you just need to release both outer sides at once to slide the seat... I disabed the latch on the inner rails so that they wont affect anything...
I haven't finished... I first was messing around trying to get a bench up front the I decided to start making a seat out of some steel rods welded together to make a seat frame... then using some thin wood or aluminum I was going to make a seat base and seat back... non-reclinable... after that comes the foam and then the vinyl / fabric and clips to hold it in place... too much money though to finish it.
I had this Vision of " A20A1 " emproidered in the seat back. :D

[A20A1]

I actually like the rail since it allows me to push the seat more left or more right then if I used stock mounting points.

[hondamanlxi]

thanks guys but, i made my own mounts completly different from yall's!

ill post pics and maybe make a how-to if you wanna contribute!


guaynabo89- you goin to nopi? pm me