View Full Version : rods...
night
10-11-2004, 10:32 AM
wtf is the rod length on these motors, i cant find it anywhere now.
rjudgey
10-12-2004, 08:54 AM
Got a few rods knocking about at home can measure it up and let you know?
B20A or A20A?
night
10-12-2004, 10:29 AM
A20
im thinking of doing a cheaper than shit allmotor build on the beater for the hell of it.
what do u have? can u get an accurate measurement? i have these motors all over the place at work but nothing to measure it with.
night
10-15-2004, 09:59 AM
:sadwave:
PhydeauX
10-15-2004, 03:23 PM
Not sure off hand what the length is, but its the same as a b18a and you can probalby dig that info up somewhere.
P.S. b18a rods work in the a20 aside from the wrist pin, one is 19mm the other is 21mm I forget which is which but any machine shop can make them work for you.
andy
night
10-15-2004, 03:36 PM
B18/20 is 137mm. deck height is practically identical too...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.