Lighter flywheel

[Accordtheory]

Well, I finally found a clutch that is exactly what I want, thanks to sean, and dave at spec clutch, so now I just need a lighter flywheel. I really would like to reduce the shock loading to the drivetrain..and a lighter flywheel is the best way.

Anyone know of any aftermarket flywheels for our cars, or has anyone had the factory one lightened?

[86LXItooFAST4me]

i told you that that spec clutch was bad ass :D

check this thread out for the flywheel:

http://www.3geez.com/showthread.php?t=39404

[AccordEpicenter]

I have an aasco and i reccomend it, Its only like about 8.5lb or so, i can drive it with the clutchnet clutch its pretty streetable, plus you can launch higher without blowing the tires away (Big plus) and youll feel it pull a little harder thru the rev range. Single most expensive part on my car and one of my fav.

[86LXItooFAST4me]

I have an aasco and i reccomend it, Its only like about 8.5lb or so, i can drive it with the clutchnet clutch its pretty streetable, plus you can launch higher without blowing the tires away (Big plus) and youll feel it pull a little harder thru the rev range. Single most expensive part on my car and one of my fav.

have you done a p&p and valve job on your head yet? cuz so far thats the most costly thing for me.

[AccordEpicenter]

i have another head im working on... gonna do a mild port job on it. Accordtheory, not to jack your thread, but did you notice a big power gain in the boosted accord by switching intake mani's? Im still on a stock lxi manifold and want more power...

[Accordtheory]

I have the aebs manifold, but it's designed for a higher revving engine than the a20. I think the 94+ LS manifold would be a might be a better choice, or maybe an aftermarket replacement (skunk2?).

[maka_RTH]

from what i've heard, the aebs may be the best manifold to stick on our engines. if i remember right it says the powerband for it is from like 2000 rpms up to like 8000 or 10000 rpms. i know that's the one i'm putting on :D

[ACE_14]

where can i get an aebs int. manifold?
how much do they cort?
is it better than sending off to Gude for one that is ported?

[ACE_14]

oops!
how much do they cost?

[maka_RTH]

you can get the aebs off of ebay for like $100-$150 i believe. they're not that much.

[ACE_14]

what modes would i have to do to fit it to my 87 lx-i? can i use all my existing vacuum lines, and not block anything off?

[Johnny O]

I have an 9Lbs alumium flywheel for sell if you are interested in it.It only has one cut on the face.It is an unorodox racing flywheel.