automatic to 5-speed: How the hell do I make my reverse lights turn on???

[POS carb]

OK, I took the console apart, according to the shop manual when the auto is in reverse there is continuity between the green/red wire and ground... well I did that (shoreted the Gr/Rd wire to the chassis) and they won't come on (yes the key was in the "ON" position, the fuse is fine)

am I doing somehting wrong or do I have an electrical problem? They were working fine b4 the swap

:rocket:

[Mac]

The green/red wire to ground will only light up the R in the dash to tell you that you are in reverse. You need to connect the green/black to the yellow wire to make the back up lights come on.

[POS carb]

gangster it works! this needs to be in the how-to (or maybe it is I think I'm part dislexic lol) I'm going to try it without the green/red. I was afraid to do the yellow-green/black short b/c it said it was the "inhibiter" circuit but when I tried it the car still started
thxs again

[Mac]

There should't be a need for the green/red to ground. You should be fine without it.

[smufguy]

HOpe this Helps you Erick. You are the 3rd person who has had this problem. I had it too, but it was because i did not have the 5spd engine bay harness that had the clips for the tranny switch. But i followed the following schematic to rig up my own from my reverse switch on the tranny to the engine bay harness so it would work and it worked fine.

click the pic to enlarge


http://img14.exs.cx/img14/4872/BackupLights02.th.jpg (http://img14.exs.cx/my.php?loc=img14&image=BackupLights02.jpg)