Prelude lip on Accord 86-89

[3GSiHatch]

Hi
I don't know if this should be posted here.. but anyway..I would like to know if any factory Honda front lips fit directly on an 87 Accord Hatch, I was wondering in particluar if the 87+4WS Prelude lip does, any help would be greatly appreciated,
Cheers
Chris

[TheSummoner101]

think this should be in the "appearance" section

and i think the g1teg lips work and 4th gen accord lips work....either one takes a bit of modefying.

btw: welcome to the board :welcome:

[Moodybluesr]

87 Preludes did not have 4ws. The first gen Acura Legend lip works almost perfectly with our Accords; it is just a little too wide. You have to cut out about an inch or two in the middle and put a cap over it. I have one ready to go on my car... if it wasn't 9 degrees outside. :D It will come with my car though if anyone buys it. I did a spot check for you on my 89 Prelude SI and it looks like any lip for that car would not quite fit a third gen Accord. The length of the side section is about 2 inches longer on the Accord, so you would have to extend the sides of the lip back to the wheel well (assuming that the width is the same).

[3GSiHatch]

mid to late 87 Preludes in Australia (where I live) have 4WS
Gen1 teg lip didn't work, I tried
Thanks for the help though I'll try a Legend lip