Bored at work= Dools

[jigga89SEi]

This is what I did at work today cause we were slow... I was gonna wait till I got the turbo engine done... But I wanted to get it done before the body work was done... So here it is...
first I had to reinforce the frame support so it didn't lose integrity...
http://www.imagestation.com/picture/sraid164/p0a92806699fef356013835266d1bb403/f4771c32.jpg http://www.imagestation.com/picture/sraid164/pb96a7657ac6f082e0084041cd912a9b3/f4771c38.jpg

Then Then I mounted the mufflers and bent the pipe then made the Y... a weld here a weld there and.. VWAAA Laaa...
http://www.imagestation.com/picture/sraid164/p37c0bab52dfbafb179faf43175436d2f/f4771c3d.jpg http://www.imagestation.com/picture/sraid164/p65c42715dc49e8d329744f08d5b1b40f/f4771c2c.jpg http://www.imagestation.com/picture/sraid164/p3a80907f346f3f2bcac0a0c2e2b6aa59/f4771c25.jpg

[danronian]

Looking pretty good.

[bullard123]

Man quad exhaust looks good. Do you feel any noticable Hp gain? How does it sound?

[jigga89SEi]

No, no noticeable gain I already had 2.25 from the headers back and a gutted cat and a 2.25 Flex pipe.... It really soundz good acctually.... I had a Tenzo R exhaust on it before and it's no louder than that....

[snow_man_20]

looks like a great lay-out.

[snow_man_20]

lol, Location = "Middle of f***ing Nowwhere", yeah me too.

[frankie89]

looks hot.. good quiality worksmanship, good job..

[johndej]

nicely done

[NXRacer]

dual exhaust is a complete waste of effort on a 4 cyl. not to mention its :rice: and looks dumb to boot! Good job! :uh:

[jigga89SEi]

Thanx for the opinions... Like I said I the reason I ran dools was for the turbo set-up... I have a stainless resonator I'll be putting on when the motor is finished, to help with the back pressure....

[NXRacer]

duals wont help a turbo setup any more than it'll help a n/a motor. Usually the best exhaust for turbo is a straight as possible 3". (maybe 2.5" if you're going low boost).

remember, the best exhaust for a turbo is no exhaust at all.

[88accordhb]

it sure is nice looking, but looks like youre loosing back pressure wince the exit pipes looks huge. if you were gonna run duals on a 4cyl 2.0, the exit pipes should be around 1.75. but looks good, bet it sounds like a weedwhacker. hehe

[jigga89SEi]

Acctually it's no louder than when I had the single tenzo R on it.... It's nice and deep, and relatively quiet at idle... it's 2.25 all the way... When the turbo's on it'll be 3" to the Y then 2.25... I haven't noticed any HP gains or losses...