View Full Version : how low can you go?
volkswagentuned
11-01-2005, 06:21 PM
I have coilovers, my question is how low can i go when i use prelude upper arms can i go as low as i want and still be able to adjust the camber? later
Strugglebucket
11-01-2005, 09:39 PM
you should be able to go about 2 inches and still get it close to 0deg.
anything lower than that and you will need to elongate the slots in the arms some.
volkswagentuned
11-02-2005, 02:27 PM
What im going for is little wheel gap or no wheel gap.
3G Jester
11-02-2005, 02:39 PM
depends on if i took my viagra or not.
oh....wait......woops.
volkswagentuned
11-02-2005, 03:05 PM
Do i have to do anything with the rear camber kit wise?
bobafett
11-02-2005, 03:55 PM
yeah you can use washers on the rear... search the forum for 'washer trick'
btw, what all is done to your corrado, i have a friend who had a lysholmed corrado running 15psi... ;-) car was fun, but fucking slow for how fast it felt
volkswagentuned
11-02-2005, 04:33 PM
The corrado is a stock g60. In a week or two its getting a VR6 swap/5 lug/lowered.
you gotta make sure its high enuf to fit a jack underneath it, my car at its stock height with a flat tire is so low the jack cant fit under it :(
volkswagentuned
11-07-2005, 01:43 PM
Nah im use to being low, i have h&r race springs on my 3rd gen prelude.
A20A1
11-07-2005, 04:20 PM
Don't you need shock/struts that can handle the lower ride, I mean won't they bottom out and limit how low you can go?
you gotta make sure its high enuf to fit a jack underneath it, my car at its stock height with a flat tire is so low the jack cant fit under it :(
I had to raise the car from the front some first using the stock car jack, then I'd fit the regular jack in from the side. I raised my car back up cause of the header clearance issue.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.