PDA

View Full Version : rod bearings - undersize vs oversize?



POS carb
11-23-2005, 11:17 AM
http://cgi.ebay.com/ebaymotors/HONDA-ACCORD-PRELUDE-1-6-1-8-2-0-BEARINGS-MS1618P-25MM_W0QQcmdZViewItemQQcategoryZ33619QQitemZ801584 8811

What would I need undersized bearings for? what would I need oversized bearings for? I thought our bearings are color-coded?
How do I choose?

Oldblueaccord
11-23-2005, 12:36 PM
The color coding is under or over sized. There matching the bearings the dimensions of the crank at the factory. I dont know what color is what bearing.


wp

shepherd79
11-24-2005, 06:14 AM
the only way to find out what bearing you need, you have to rip the engine apart.
You can find more info in shop manual.

88Accord-DX
11-24-2005, 06:18 AM
Yeah, you need to tear the engine apart & plastigauge the main & rod bearings to determine what oversized bearings you need.
Depending on if you have your crankshaft turned, the machinist will inform you to the appropriate size bearings to buy.

Kabuki
11-28-2005, 04:30 PM
Yeah, the color coding is stupid. The amount of differences in size are .0001", and there is usually less variation than that in "standard" bearings. We just buy the standard bearing set and mike each unit, and the journals on the crank. then match them up. It's far less expensive (than $11 per bearing HALF from Honda), and works just as well. I'm currently using NDC rod bearings and ACL main bearings & thrust washers in my Accord. No trouble in 8000 miles (1.5 years, just don't drive much).