AccordRacing21
12-17-2005, 11:00 PM
Hey guys, I have an 89 Accord Coupe LXi and I had a few questions....
Question 1: When I'm adjusting my drivers side mirror it works fine, but it moves the passenger side one at the same time, then when I try to adjust the passenger side one it will only move right or up. Is the switch bad or something worse?
Question 2: I know this has been touched on before, and I have read all the search threads, but I just wanted to verify before I spent the money. I can roll my drivers side window up and down but the passenger window only goes down (this is from the drivers side controls). I read that the little regulator or w/e in the drivers door is the problem, but I'd like a verification.
Question 3: I ordered the Arospeed strut bar a couple days ago, but when I was looking under the hood today I saw that the strut mounts are sunk down below the intake manifold. I was wondering if this is going to clear my intake okay? I have a cone air filter off the end of the intake manifold, similar to another one I've seen on this forum.
Thanks for the help.
Question 1: When I'm adjusting my drivers side mirror it works fine, but it moves the passenger side one at the same time, then when I try to adjust the passenger side one it will only move right or up. Is the switch bad or something worse?
Question 2: I know this has been touched on before, and I have read all the search threads, but I just wanted to verify before I spent the money. I can roll my drivers side window up and down but the passenger window only goes down (this is from the drivers side controls). I read that the little regulator or w/e in the drivers door is the problem, but I'd like a verification.
Question 3: I ordered the Arospeed strut bar a couple days ago, but when I was looking under the hood today I saw that the strut mounts are sunk down below the intake manifold. I was wondering if this is going to clear my intake okay? I have a cone air filter off the end of the intake manifold, similar to another one I've seen on this forum.
Thanks for the help.