AccordRacing21
02-12-2006, 10:12 PM
Since I have harnesses I took the drivers side seat belt out. Inside the door panel where the seat belt is at in the door there were two wire clips going into it. I unhooked them and now the seat belt light keeps blinking and it doesn't stop beeping ever. I know for sure that removing the part it snaps into on the seat isn't the issue because it never started until I took the actual seat belt out. I was wondering if anyone knows why there are even wires going into the seat belt roll up thing, how I can make it stop beeping, or if someone has a wiring diagram for this, or any information on this at all will be helpful.