PDA

View Full Version : fuuuuuuuuuuuuukk


POS carb
08-21-2002, 08:53 AM
man my tranny mount is all twisted up and the motor slams the firewall when I hit the gas and I have oil leaking. goddamnittttttiiwaoiaszu9ibzsergi;bjzervlbkhzdfviu hzd:chainsaw: :banghead:
Vanilla Sky
08-21-2002, 09:57 AM
sounds like you went racing

Derick
netfreak
08-21-2002, 10:03 AM
!!!!!!!!! Whoa man.
carotman
08-21-2002, 11:04 AM
souns like you need a B20A to me
88turboaccord
08-21-2002, 11:07 AM
Bring the car by, we will get that shit fixed right..
1988starter
08-21-2002, 12:15 PM
Yup this post needs some more content from POS
carotman
08-21-2002, 12:22 PM
just put some eurethane in those :)

miam miam miam
SQ is the SQUAD
08-21-2002, 12:29 PM
where is the oil leaking from?


it is a pleasure for me to reply in this post with the rest of the post whores
ACCORD EX
08-21-2002, 12:45 PM
all that suddenly happened ! what have you been doing with your car Eric ! :p :D

MIKE
POS carb
08-21-2002, 02:45 PM
fuck my tranny is leaking lots of oil from the right side and it's not from the drain or the dipstick or the vent. It's oozing onto the wheels and shoots it everywhere! Arrrrgh!
A20A1
08-21-2002, 05:43 PM
geezus....
Bobs89LXi
08-21-2002, 05:45 PM
You haven't been doing any more of those burnouts have you, Eric?
Jims 86LXI HB
08-21-2002, 06:56 PM
Damn eric, that sucks!

Way to go justin for offing to help him.:super:
Jims 86LXI HB
08-21-2002, 06:57 PM
Originally posted by Bobs89LXi
You haven't been doing any more of those burnouts have you, Eric?

:lol LOL bob!
A20A1
08-21-2002, 07:20 PM
hmm are you sure it's not a hose that burst? I know that mine burst but the hole was so small i couldn't see it right away...
hondaisthebest
08-21-2002, 08:01 PM
i have just resolve the same problem that you yesterday but it was atf fluid that was leaking from the driveaxle seal at the right.
The seal cost me 5 bucks and it take me 30 minutes.
Are you sure that its oil or atf fluid???

ps:i am not exacly sure that its the driveaxle put it the same stick that were is connected the cv boots.
POS carb
08-21-2002, 10:04 PM
hey mike I'll chec out the hose because I don't see anything there that can do this kind of mess. It's not coming out by the axles either, it's coming from somewhere under the battery, it's too dark to see, I'll give it a good look over tomorrow. Oh and yea, I'm positive it's ATF. Probably the fault of my ghetto cooler.
A20A1
08-21-2002, 10:10 PM
Oh you most likely will have to fill the trans up with fluid again then do a gear change or something to start moving the fluid thru the lines..... and what ghetto cooler did you rig up?

have you ever replaced the trans cooler lines before? cause when I tried to take mine off they just snaped.

Eric how ya supposed to run the 38 if you don't have the trans working.... and I just got one step closer to beefing up my bottom end power. check the carb tech.
POS carb
08-22-2002, 10:30 AM
hmm looks like it may be that tranny/axle seal, I don't see anything else indicating it's coming from a line... It all runs down the axle to the hub and flies EVERYWHERE. I just hope the spring on the seal didn't fall into the trans.

Hondaishtebest, can you give me more details I don't quite understand that last line :p
Where'd u get the seal for $5? Oh and what was the part#?
POS carb
08-22-2002, 10:46 AM
http://www.hondaautomotiveparts.com/catimgs/13SE00_C03.gif


#20??
POS carb
08-22-2002, 01:48 PM
nevermind, I figured it all out, car runs fine now but alot slower thanks to my 100+lbs in the trunk :D
hondaisthebest
08-22-2002, 08:07 PM
I found the seal at honda dealer for 8$canadian bucks about 5-6$us dollars.
I thinks that its the seal number 20.
You have to remove the right wheel and disconnected some of the the balljoint. Give us new!!!

ps:the name of the part you have to take out to reach the seal is the halfshaft or driveshaft.