front turn signal replacement

[sjsjbb]

im trying to replace bulb in fornt turn signal how do u get the darn thing out iv tried just about everything. cant fit my hand up in there to turn it and there are no screws on lense. have look at threads and cant find thanks

[89AccordResto]

Why is this in EFI tech?

[DBMaster]

If you are talking about an 88 or 89 you remove the filler piece under the light on the bumper (the place where the factory driving light would mount). If you look up into the opening you can see a hole. You can use a #2 phillips screwriver in the hole to loosen the screw which holds that side of the light. You can then pull the light out on that side and slide it toward the middle of the bumper and it should come out. Pretty hard to explain, but once you see the whole and loosen the screw (It is in a plastic holder so it will not fall out) you will be able to figure it out.

[sjsjbb]

tks seen hole. will try also tried to post where it was to go and had trouble still trying to figure this out here thought i had but i guess i was wrong .

[sjsjbb]

tks and found it it took 10 min to change tks for info