PDA

View Full Version : Connecting rod play?


BITESIZE
03-27-2006, 05:37 PM
How much play should be on the connecting rod while attached to the crank. I have a slight bit on each rod. I'm talking about side to side not up and down on the bearings.
88Accord-DX
03-27-2006, 06:03 PM
Connecting rod end play
Standard.............................. 0.006 to 0.012 in. (0.15 to 0.30 mm)
Service limit........................... 0.016 in. (0.40 mm)
BITESIZE
03-27-2006, 06:12 PM
They are all at .012 in. So I'm fine Thanks Man! I could hear a little clicking when I was turning the crank, it's got to be that, because all the bearings are fine.
SteveDX89
03-27-2006, 07:25 PM
Don't you have a shop manual or at least a Hayne's? It's all in there.
BITESIZE
03-27-2006, 07:29 PM
It's in the wifes car and she is at work...;) Went out of town and did some reading and I left it in her car the other day.
SteveDX89
03-28-2006, 09:58 AM
It's in the wifes car and she is at work...;) Went out of town and did some reading and I left it in her car the other day.

:slap: