PDA

View Full Version : urgent: I need to swap my engine, I need ur help



neremon
05-28-2006, 12:44 AM
I have accord 88 EX 2L carb. Automatic, and i have some proplems with it so I need to change the moter with the transmission to 1.8L Engine...
I need your help, what is the best motors (carb.) would be berfect to my accord w/o any modification in the mounting or any thing, just to remove the old one and install the new one

mkymonkey
05-28-2006, 01:44 AM
to tell ya the truth the best motor would probably be the same as you have now. but since youre going to swap motors, i say get one thats FI and convert to a 5speed you wont regret it

2drSE-i
05-28-2006, 09:29 AM
no engine swaps are available without changing motor mounts except the stock accord engines and the jdm b20a. i dont know if there are any carbeurated b20s that would fit.

neremon
05-29-2006, 12:12 AM
to tell ya the truth the best motor would probably be the same as you have now. but since youre going to swap motors, i say get one thats FI and convert to a 5speed you wont regret it


OK you are right that the FI is better, so what engine can be fit, I've read about the B20 and B18 what do you think...:cheers:

Whistler225
05-29-2006, 04:08 AM
Don't forget that if you put a FI engine in your car, you will also have to change the fuel tank, filters, pump, and the cabin wiring harness, as well as the ECM.

snoopyloopy
05-29-2006, 04:48 AM
could do the b18 (from the accord, not integ). that's carbed stock. or stick an a18 in there. either one is basically bolt in and run. or another carbed a20.

AccordB20A
05-31-2006, 09:26 PM
i have an idea..b20a block b18 head with twin carbs :D.. or u can put ur carbs off an a20 and stik em on da b20 and see how that goes?!?!?!..just an wacked idea i had...

neremon
05-31-2006, 11:36 PM
Dear all
I've now in my car a v-good A18 carb engine.


Anyone here has all the A18A specs?


Like HP, torque, Compression Ratio, number of valves total displacement

Thanks

snoopyloopy
06-01-2006, 09:27 PM
think lower numbers than a carbed a20 for hp and torque, idk about the c/r. the number of valves should be 12v at 3/cylinder. displacement is in the name. 18 = displacement = 1.8 liters.

AccordB20A
06-03-2006, 01:40 AM
i have one of those. isnt the a18as HP like 110?

snoopyloopy
06-03-2006, 07:10 AM
were they carbed or pgm-fi? or both?