View Full Version : injectors and an FMU
newaccorddriver
06-25-2006, 03:33 PM
i was wondering if i must use an FMU with larger injectors. i was reading something from G2IC and it says that factory turbocharged engines dont need rising rate fuel pressure regulators but instead use larger injectors.
if i use DSM 450cc injectors, would i still have to use the FMU or would i be safe using my stock FPR
AccordEpicenter
06-25-2006, 04:53 PM
do not use an FMU. Stock FPR will be fine for boost
newaccorddriver
06-25-2006, 05:12 PM
atleast i dont have to buy an FMU for my setup. what about fuel pressure, is stock fuel pressure enough to support the extra air? i guess a new pump would fix that problem as well
AccordEpicenter
06-25-2006, 06:40 PM
dsm 450cc injectors are good to a ballpark of 300hp. If youre going for over 200whp then you need to get a bigger fuel pump, a walbro 190lph or 255lph intank will work good. Stock fuel pressure is fine
newaccorddriver
06-25-2006, 07:26 PM
dsm 450cc injectors are good to a ballpark of 300hp. If youre going for over 200whp then you need to get a bigger fuel pump, a walbro 190lph or 255lph intank will work good. Stock fuel pressure is fine
basically all i needed to know:)
is the only difference between the walbro 190 and my stock 190 just the fuel pressure it make?
AccordEpicenter
06-27-2006, 06:08 PM
stock is like 70lph i think... walbro 255lph intank supports 550hp or so
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.