Fi Conversion for a 86 carb accord.

[ironsamurai]

hey does anyone have the parts list i would need to do the Fi conversion on a 86 accord? i need to know erything i need to do this so i can get it done. want to do it soon. my engine went bad and i wanted to get a fuel injected motor just think it will be better. If you know what i need or just have some thoughts on the matter please let me know.:rockon: :rockon:

[A20A1]

Get a A20A3 swap.

EDIT: wait you're not a 2 G, I should read the title and post a little more carefuly next time.

it'll fit.

Oh and don't post in the 2G forum This is for 82-85 accords.

Iron Samurai is a cool name... it fits with the iron blocked motors. :)

[ironsamurai]

yeah i can get the engin no broblem there is someone selling one for $150 in my area but i need to know what else i will need some one told me there was a write up on this very subject somewhere on this sight but i cant find it.:repost: i already bought the new ecu i need from a 89 LX-i but i dont know what else i need. would i need a new fuel pump?

[forrest89sei]

yeah i can get the engin no broblem there is someone selling one for $150 in my area but i need to know what else i will need some one told me there was a write up on this very subject somewhere on this sight but i cant find it.:repost: i already bought the new ecu i need from a 89 LX-i but i dont know what else i need. would i need a new fuel pump?

Since you have a 89 LX-i ECU I'd use 89 lxi parts since it has the highest HP numbers.

ALL OF THIS INFO IS BY Carotman
You Need:
* Alternator (the PGM-Fi system uses an extra wire)
* Atmospheric pressure sensor (located under the heater blower)
* Cabin wire harness
* Coolant splitter
* Distributor
* ECU
* EGR Pipe
* Engine bay wire harness
* Exhaust manifold (88-89 only)
* Fuel feed line back to the fuel tank
* Fuel filter assembly
* Fuel pump
* Injector resistor box
* Intake manifold holder bracket
* Oxygen sensor (88-89 only)
* PGM-Fi intake manifold: This includes the injectors and all the sensors
* PGM-Fi Vacuum control box
* Main relay
* Metal coolant pipe behind the engine
* Thermostat assembly
* Throttle Cable
Suggested parts:



* Dash wire harness, to have the PGM-Fi light harness

* Fuel tank: UPDATE The PGM-FI fuel tank has special chambers inside and you need it to fit the EFI pump unless you modify your carb tank
* Gauge cluster: will allow you to have the PGM-Fi light

Heres a link for a how to by Carotman, it has the full parts list
and all the info you need to do it:

http://www.geocities.com/carotman/howto/eficonv/EFIconversion.htm

Welcome to the forum

[ironsamurai]

Thanks a lot man this will help me out a lot:rockon: