Tranny swap

[Xtreemjedi]

I know there is info on 5spd swaps, I read them, all I am looking for is ppl with EXPERIANCE doing the swap, preferably one on an EFI '89 a20a3. What all parts I should get from what kind of vehicle, like i've seen ppl use ones from the accords, ludes, and integras. I want to hear what ppl have to say AFTER they have acctually done one. Problems they came across, parts they forgot, or fabricated for the job. Perfomance differences. What parts I should get used, what parts I should just get new. That kinda stuff.

[LiTtLe xOx BitT]

I did mine right off the how to section, theres just one thing you need thats not on there which is the starter mount. Its about a 2.5 day job, and i reccommend getting a new clutch kit and flywheel. You can use a tranny from another 3gee accord or the lude with the a20 motor i beleive. If you dont have much experience with things like this i wouldnt reccommend it at all because it is a lot more work then it sounds. If your positive you want to do it and you have any questions that arent answered on the how to the message me.

[Xtreemjedi]

Sweet, i'm not going to do this myself, I don't have an engine lift, so I can't do it myself even if I could put my car down for that long. It's my only car. I have a buddy who is the GM for a couple of Midas near me and he does my work that I can't [or don't want] to do. He cuts me a break on the labor and I don't have to pay tax or anything.:rockon:

[LiTtLe xOx BitT]

engine lift?? you dont need a engine lift i did it on jackstands in a driveway.

[BITESIZE]

It's easy to do, just takes time. I added alot of information in the how to section. Make sure you have all the stuff you need to do it first. P.S. you don't need a lift. Just alot of good tools.

http://www.3geez.com/forum/showthread.php?t=102&highlight=bitesize+swap

http://www.3geez.com/forum/showthread.php?t=23117&highlight=bitesize+swap

http://www.3geez.com/forum/showthread.php?t=22880&highlight=bitesize+swap

[Xtreemjedi]

Sweet, thanks guys!:wave: