PDA

View Full Version : Plastic Primer questions...



Jasonf860
10-06-2006, 05:26 PM
:rant:Ok, I'm in process of painting some plastic, hence the plastic primer. It got cold on me quick as I was spraying the primer and i got a run. It's small but it's there none the less. I'm wondering if I can sand the run out of the primer without it loosing it's adhesion promoting carachteristics. Anyone know? On a side note, I get to change my water pump tomorrow morning! YAY! :mad:

MessyHonda
10-06-2006, 05:52 PM
you can try to wet sand it with a fine grit....also you can respray some adhesion promotor.

Jasonf860
10-06-2006, 06:13 PM
Thanks Messy, I think I am just going to spray some "filler primer" over the plastic primer and use that to smooth out any roughness/runs/pits. hopefully that works out!