View Full Version : intake question
ninja2571
09-03-2002, 05:09 PM
ok , ive got a 89 lxi 4 door bla bla bla , anyways will a 92 civic intake fit my engine, everyone in here who done it from a 92 civic intake has like 88 and 86's , will it still work......and what all do i need, i seen a 92 - 94 civic intake just the polished alum part no filter, made by apc , if i get that and a filter will that be it , and how much do i need to cut off to make it fit............thanx :werd:
anchovies
09-03-2002, 07:41 PM
Yes, doesn't matter which year, as long as it's FI.
How much to cut? Try and test fit it first before cutting to be sure.
1988starter
09-04-2002, 12:06 PM
I needed about 4 inches just look and measure by eye because the filter will cover up the cut. Here are some picts
http://www.geocities.com/geezpict/eng1/eng1project.html
jlaccord89lxi
09-04-2002, 04:11 PM
where can you buy the rubber couplers? You know, the short rubber peices you put halfway onto the intake tube and half on the filter/manifold then put those round clamps on and tighten it so it stays connected?
1988starter
09-04-2002, 04:42 PM
MY AEM One came with All that stuff along with all the grommits and plugs needed for 86 and 87 models it is a 92 BTW.
smufguy
09-04-2002, 06:02 PM
why do u wanna by a APC one? just make ur own from a U pipe.
87pimpsterdocious
09-04-2002, 10:50 PM
Originally posted by jlaccord89lxi
where can you buy the rubber couplers? You know, the short rubber peices you put halfway onto the intake tube and half on the filter/manifold then put those round clamps on and tighten it so it stays connected?
you can buy them at any hardware store in the plumbing section near the pvc piping.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.