Front turn signals

[Blkblurr]

How do you remove the front turn signals on an 89 SE-i? The manual shows screws in the front of the turn signals but they do not have them. I assume you need to remove the underside covers and pull them out from inside the bumper.

[ghettogeddy]

are u talking corner or bumper

[A18A]

sounds like the bumper ones
http://i154.photobucket.com/albums/s248/87vigor/bumperlight.jpg

[ESDEEZ]

what if you had fogs there?

[Toneloc5145]

what if you had fogs there?

You could just unplug the fogs. Or do what I had to do since my holes are covered up by my kit. I had to take the whole bumper cover off just to have access to the screws that hold the lights in.

[Blkblurr]

Thanks guys. that's what I needed.

[MessyHonda]

yup its easy once you know how to take them out.

[A18A]

what if you had fogs there?
i had fogs there, its a pain in the ass to get them out, especially if you're sitting on sharp stones

[Blkblurr]

Well I got the turn signals cleared by using a dremel and a cutting bit from a rotozip used for drywall board and wood. I don't recommend this method unless you are good at using this setup. I just cut the amber lens sides and bottom in half then pulled it out. I used my air compressor to blow out the cuttings after that. It took me about 20 minutes per turn signal. I am putting the 3watt LED bulbs in place of the original type.