cylinderhead gasket

[pedrosa]

hi guys

I´m going to fit new pistons 0.5 oversize on b20a2 engine (black top), I´ve a question, the cylinder head gasket must be standard or oversize also??

thanks in avance

[88Accord-DX]

.050" bore is little over a millimeter, so I would look into finding Over-sized head gasket also. Don't need that much over-hang of copper gasket in the combustion chamber.

(assuming you mean .050 & not .50 )

edit- If you mean .5 mm, .020" bore. Copper gasket standard size should be ok. (from my experience)

[pedrosa]

0.5mm not 0.5". ??

[88Accord-DX]

0.5mm not 0.5". ??

.5 mm = .020" overbore, you should be ok with standard copper head gasket.

[pedrosa]

many thanks:)

[bobafett]

yes .5mm you will be fine with any stock gasket!

I do in fact have a .050" (inches not mm) bore and I had to use a custom head gasket. Cost wasn't too bad, but getting it to seal was a nightmare until I learned all the tricks with copper gaskets!

consider yourself lucky! :) :)