Log in

View Full Version : need help


twizted_ninja
10-12-2007, 03:08 PM
2ndgenguy i know you got the weber on your car right. i was woundering if you could tell me where i can get an adaptor plate or even f it needs one and also what i need to do to get it to installe correctly. thanks
2ndGenGuy
10-12-2007, 03:40 PM
I got my adapter plate from piercemanifolds.com. Carbsunlimited.com also has them. Yes you need one. :D

Installation is easy. Remove old carb and 500lbs of emissions stuff. Bolt on new carb, connect throttle, connect fuel, connect 12v choke! If you buy a new carb in a kit, it should come pretty close to pre-jetted. If not, you'll need to make sure it's properly jetted.
twizted_ninja
10-14-2007, 12:38 PM
right on bro, thanks alot i couldnt find one any where
2ndGenGuy
10-14-2007, 05:51 PM
This is the kit:

http://www.piercemanifolds.com/Images/Catalog/K727.htm

http://www.piercemanifolds.com/Catalogpages/honda.htm

Kit K727. You might have to call them to order it.

Or from Carbs Unlimited:

http://www.carburetion.com/weber/Dataresults3.asp?Kit_Nbr=K727&Model=ACCORD

The kit number is the same no matter where you buy it.
twizted_ninja
10-25-2007, 01:20 PM
hey could you tell me what all needs to stay and what all can go when i put the weber on there please
thanks
2ndGenGuy
10-25-2007, 03:26 PM
Everything will go. Once you start ripping carb stuff off, it will become more clear as you go along. The only think you'll need to hook vacuum lines to (from the intake manifold, not the carb) are the cruise control (if you have it), vacuum advance, and HVAC.
twizted_ninja
10-26-2007, 08:35 AM
ok so no cruise , already got hvac but where would the advance go from
twizted_ninja
10-26-2007, 10:56 AM
another one for ya, http://www.3geez.com/forum/showthread.php?t=60666 , in the first picture theres the vaccum ports where do you got them going to.
twizted_ninja
10-30-2007, 01:19 PM
re
2ndGenGuy
10-30-2007, 01:55 PM
Vacuum is the same on any of those ports on the intake manifold. So just run a vacuum line from the advance on the distributor to any of those bungs on the manifold. Or you can put a Y in the vacuum line going to the HVAC and tap it that way. Either way works. :D

Oh yeah - you might 2 advance ports on the dizzy - the Weber HowTo for the 3g will show you which one to hook to, since they're the same. And since I don't remember myself.