PDA

View Full Version : who can fix a bellhousing


AccordB20A
12-13-2007, 01:53 PM
there are many holes in it that will need alloy welding. But since i dont need my b18 gearbox anymore i would sell it to someone on here. But it needs someone to weld and repair it cause it has a few holes and a leaky axle seal
Oldblueaccord
12-13-2007, 03:48 PM
Needs to be TIG welded. it most likely needs to be totaly disassembled so it can be cleaned to be welded.

Another way is you might try Alumaloy you use a torch to heat it and the area sorta like brazing.


wp
2ndGenGuy
12-13-2007, 04:54 PM
This is the bellhousing that will let you hook an A20 gearbox to a B20 motor, correct?
A18A
12-13-2007, 06:38 PM
Correct.
fogged
12-13-2007, 08:55 PM
Tig is not the only way. You can mig it if you have the right wire, but tig is a better way. I dont like the Alumaloy.
MessyHonda
12-14-2007, 02:32 AM
just JB weld the SOB together...haha
A18A
12-14-2007, 03:03 AM
thats hory
AccordB20A
12-14-2007, 03:34 AM
at the moment the holes are blocked with rivets and shet steal with some fibregrlass filler over and the gearbox is rebuild. It works just missing a bit of alloy from around the axle seal.
AccordEpicenter
12-14-2007, 06:30 AM
lol why are there holes in the bellhousing?
labeledsk8r
12-14-2007, 07:02 AM
lol why are there holes in the bellhousing?

im thinking the same thing lol

post pics of it so we could tell if its fixable.. if it is im sure it will get snaged up since a bell houseing is alot cheeper the na b20 tranny... and it works the same