PDA

View Full Version : I got some good news today about my B20a



RCracer
09-19-2002, 02:49 PM
I had my B20a checked today and the bores are good (just needs glazebusting) and the crank is still within tolerances.

So its going to need piston rings, bearings (big end, mains), water pump, timing belt tensioner, oil pump service kit, timing belt and the flywheel resurfacing together with a new clutch.
Then Ive got to get some new CV joints and a new intermediate shaft bearing.
If things keep going as smooth as this with it I should have the swap done in the next 3-4weeks (with a bit of luck)
I am going to put the pedal box and clutch cable in over the weekend ready.

Then when its running on the carb its time to get a weber and get it tuned. All after its been run-in.

MoonScryer
09-19-2002, 07:00 PM
Well, when you are done, you'll have a completely new engine, or pretty damn near. Nice job.

A20A1
09-19-2002, 07:37 PM
OMG I have that exact same chest setting in my living room... and its filled with car junk. :D

good luck getting all the parts.

1989 DX R
09-19-2002, 08:03 PM
Swank! I wanna see some more pics of this beast when its done!

YK86
09-19-2002, 10:49 PM
Keep us informed!