View Full Version : Splash Guard
nfs480
02-21-2008, 11:03 AM
I was driving down the steep hill in my driveway when I started to slide on the ice that had built up. I slid into a bank and was able to back out again just fine. However, the splash guard under the car near the front bumber is all torn up. I looked on Majest Honda and they aren't expensive, but I was curious, how difficult are they to remove and install? I'm willing to bet it's relatively easy, but i'd like to know before I order the thing. Thanks.
2drSE-i
02-21-2008, 11:14 AM
I was driving down the steep hill in my driveway when I started to slide on the ice that had built up. I slid into a bank and was able to back out again just fine. However, the splash guard under the car near the front bumber is all torn up. I looked on Majest Honda and they aren't expensive, but I was curious, how difficult are they to remove and install? I'm willing to bet it's relatively easy, but i'd like to know before I order the thing. Thanks.
its easy, just a few bolts. A couple of them are behind the wheels and hard to get at, just use some extensions andyoull be fine.
nfs480
02-21-2008, 01:10 PM
Great, thanks for the info.
2drSE-i
02-21-2008, 01:10 PM
hey no problem, you mind linking me to where you found that, i spent 20 mins looking...
russiankid
02-21-2008, 01:20 PM
hey no problem, you mind linking me to where you found that, i spent 20 mins looking...
http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=ACCORD&catcgry2=1989&catcgry3=4DR+LX&catcgry4=KA5MT&catcgry5=FRONT+FENDER
Goes with the front fender.
2drSE-i
02-21-2008, 01:23 PM
well thats a retarded place to put it....
edit
wow those really arent too bad, ill probably pick one of those up when i get busy with my rebuild
MessyHonda
02-21-2008, 05:31 PM
i took mine out.
russiankid
02-21-2008, 05:37 PM
i took mine out.
Not a good idea as water splashes everywhere(including the alternator) and if you hit a something like a curb you run the risk of damaging the radiator and oil pan.
MessyHonda
02-21-2008, 05:44 PM
the lower crossmember would take the beating. i would of put it back but it was all scratched up and it sucked taking it out and putting it back on when working on the car
nfs480
02-21-2008, 06:10 PM
Yeah, I live on a gravel street and in the winter time or when it rains there's always muck flying everywhere. The splash guard is practically a necessity here.
2drSE-i
02-21-2008, 07:52 PM
i just dont like the idea of water cooling a hot block. I know it can take it, but i just dont like taking chances.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.