PDA

View Full Version : Can't see Diagram - "How-to wire sidemarkers"



marklj
03-30-2008, 01:52 PM
I can't see the diagram in the post for "How-to wire sidemarkers".

(3geez » Information » How To » Engine & Body Electrical » How To , Wire Sidemarkers)


Looks like the link has gone AWOL. Any way I could view the diagram?

AWOL link:
http://www.3geez.com/images/uploaded/1-wiring.gif


Thanks.

Bass Man
03-30-2008, 07:22 PM
Negative...

What do you need help with wiring?? I'm guessing you are putting those oval markers on your fender, am I right?

marklj
03-31-2008, 10:02 AM
No oval side markers. I was try to figure out a way for the front bumper turn signal lights to stay on all the time (for day time running lights) but still blink for turn signal operation. Similar to some GM products like the ’70 & ’80 pickups. The front side marker light stays on, but blinks with turn signal operation. Ideas?

Bass Man
03-31-2008, 10:31 AM
Splice into your sidemarkers, I guess. I could do it in about 20 minutes, but I'm not sure that is the way you are wanting to approach this.

89T
03-31-2008, 03:47 PM
relay on each light to a switched source, using your original turn signal wires to trigger the relay.
its been so long since i have even looked at a relay to tell you how to wire it.

i'll give it a shot though.you need 2 5 pin relays one for each side.

top pin =open (no wire)87
left pin =turn signal wire ?
middle pin = light bulb wire 87A
right pin =ground ?
bottom pin= switched source 30

the ? are for the pin #'s ignor the ..... the vertical/horizontal lines represent the pins. 30 on the bottom.
....l....
.l..-..l.
....l....

marklj
04-01-2008, 11:31 AM
Cool. Thanks for the suggestion!