PDA

View Full Version : car won't stay running



durnut
04-20-2008, 09:02 PM
First off, I would like to say hi and this is my first post here. I have found some very useful information on this site that has helped me with my altinator problem. ok, now to my problem.

I bought an 88 accord for $400. I knew there where going to be some issues to deal with down the line but not ten minutes after i got it on the road. The car would drive fine but stall whenever i push in the clutch. I said the hell with it, i'll drive it as long as it runs fine. one night while driving it, i was down shifting into fourth, it stalled, so i pop started it like usual, it bucked real hard and the battery light came on but it ran perfect frome then. The car didn't stall, idled fine, perfect. a day or two later, battery went dead. I found out it wasn't taking a charge, i figured it was the altinator. What a bitch of a job. i didn't have an axle nut so i had to drop the frame to barely get the altinator out. alt job was done but the light was still on, the next day i climbed under and noticed that the pivot bolt wasn't tightened all the way. I tightened the bolt up, started the car up and the light was gone, bad ground i assume. Here is the kicker, as soon as i fixed the altinator, the stalling came right back. I changed the fuel filters, adjusted the idle and it still stalls. I think it might be the carb but, thats a job i know very little about. sorry for the novel but if you guys have any advice on other little things i could be missing,help would be greatly appreciated. Thanks much.

GraniteLXI
04-20-2008, 10:33 PM
:welcome: Strange problem, I'm not sure what is going on in your case because i dont have any experience with a carb'd accord, but im sure others will be able to lend you a hand. Be sure to post some pics :)

durnut
04-20-2008, 10:41 PM
i will post asap. im surprised there isn't much rust on the car considering it's an 88.

Hauntd ca3
04-21-2008, 12:12 AM
check the alt output voltage.
i had some strange probs when the regulator packed up and was charging at 18v at idle

durnut
04-21-2008, 12:22 AM
check the alt output voltage.
i had some strange probs when the regulator packed up and was charging at 18v at idle

The altinator charges at 14.7, it's charging normally

greentee76
04-21-2008, 01:21 PM
Check the primary slow mixture solenoid valve on the back of the carb. This solenoid is vital to idle. Instructions for testing it can be found on page 11-39 of the online manual at http://http://www.pauldesign.ru/honda/shopmanual.html
I am not sure that this solenoid hanging up would be enough to drain your battery but it is a possibility that relates to your no idle situation.
Good luck with it.

durnut
04-21-2008, 08:05 PM
Check the primary slow mixture solenoid valve on the back of the carb. This solenoid is vital to idle. Instructions for testing it can be found on page 11-39 of the online manual at http://http://www.pauldesign.ru/honda/shopmanual.html
I am not sure that this solenoid hanging up would be enough to drain your battery but it is a possibility that relates to your no idle situation.
Good luck with it.

i'll check the valve thing tomorrow. I already fixed the charging issue, bad alt, although when i hit a big bump the plug pulls out of the altinator and the battery light comes back on. kind of a pain to have to keep pulling over and plugging that back in.

durnut
04-23-2008, 11:09 AM
Well, i feel a little stupid, the car idles and runs fine now. It needed to be idled up a little. Thanks to everyone.