tenchimuyo93
07-06-2008, 09:35 PM
as the title states im new to hondas {except for general repairs}, as my previous project cars have been a 83 nissan maxima wagon {2.8 l6 stroked to 3.1 with triple side draft webers 300z trans, rearend/suspension and front suspension} and a 87 200sx {RB26 swap with skyline trans, 300z rear carrier/gear set.}
hope to learn a few things about these hondas here.
forgot to mention, picked up my 87 accord from a family member {im thrid known owner} when they got a 4g.
to the best of my knowledge it has 250k orginal miles on the long block and running gear. no major problems, though i had to replace the water pump and unfreeze the rear self adjusters.
plans for this old girl are as follows.......
Weber 32/36 {found someone that can order loacaly :) }
rear disk brakes
front driiled/slotted rotors {and upgrade calipers if i can pull it}
front and rear sway bars
1.75 springs from intrax, i havent found the shock/stuts i want yet
subframe connetors {hand made}
6 point roll cage {for ridgety}
header/high flow cat/cat back {prefer quite setup with cutouts for the sleeper effect but we shall see}
head port and polish
short block stregthing/bluepright/high speed balance/H-beam rods {if can be found}
Wet nitrous kit, 150 shot kit max
and no body work unless it has to have it to be safe, i like to hide till i strike.
Ryan/Bizkit
hope to learn a few things about these hondas here.
forgot to mention, picked up my 87 accord from a family member {im thrid known owner} when they got a 4g.
to the best of my knowledge it has 250k orginal miles on the long block and running gear. no major problems, though i had to replace the water pump and unfreeze the rear self adjusters.
plans for this old girl are as follows.......
Weber 32/36 {found someone that can order loacaly :) }
rear disk brakes
front driiled/slotted rotors {and upgrade calipers if i can pull it}
front and rear sway bars
1.75 springs from intrax, i havent found the shock/stuts i want yet
subframe connetors {hand made}
6 point roll cage {for ridgety}
header/high flow cat/cat back {prefer quite setup with cutouts for the sleeper effect but we shall see}
head port and polish
short block stregthing/bluepright/high speed balance/H-beam rods {if can be found}
Wet nitrous kit, 150 shot kit max
and no body work unless it has to have it to be safe, i like to hide till i strike.
Ryan/Bizkit