ecu harness

[87SIA20A3T]

where does the ecu wire harness go from the engine bay to the actual ecu? I ask because I want to install my afc and i am not sure where it is, and i do not want to actualy ripe most of the car apart in effort to find it.

[A18A]

umm they go from the engine bay then run through the inner fender through a hole in the side of the car and down to the ecu, you will have to cut & paste a few of the wires if you want to run a stand alone

[87SIA20A3T]

so they go through the whole in the engine bay and through the side of car next to the drivers side back to the ecu under the ash tray behind the driver? does anyone have a layout of the wires? like what is what and what color they are?

[2oodoor]

prelude or accord?

[snoopyloopy]

haynes manual ftw?

[AccordB20A]

prelude its on the left under the rear ash tray in the back, accords one is under the left seat i believe

[87SIA20A3T]

so thw wires travel from the engine bay through the middle of the car (through the area with the shifter) and then go behind the driver and too the ecu? does anyone have a diagram of the wires? or anyone install a afc?

[87SIA20A3T]

bump

[A18A]

it goes like this
http://i241.photobucket.com/albums/ff295/88vigor/fgrehrtjynfgk.jpg

[87SIA20A3T]

sweet thanks

[87SIA20A3T]

does anyone have a wire diagram of the wire hareness, i.e. what color wire coordinates with what?

[A18A]

http://carotman.no-ip.com:8888/personal_site/tech/ecu_pinouts/pinout_list.html

[SteveDX89]

it goes like this
http://i241.photobucket.com/albums/ff295/88vigor/fgrehrtjynfgk.jpg

This is mostly true. There is a part that runs along the firewall inside the car out through another hole on the pass. side.

[87SIA20A3T]

thanks to all

[Vector]

dont forget black box,(map, emissions, ac idle boost, cold idle boost) and other wiring for charge system, reverse lights, starter, all run through passenger side fender by black box i think. atleast they did on my 88 hatch.