SPC rear upper control arms

[nswst8]

Okay guys here they are the rear upper control arms that I just put in and I highly recommend them.

http://cgi.ebay.com/ebaymotors/SPC-REAR-CAMBER-ARM-KIT-HONDA-86-87-88-89-ACCORD_W0QQcmdZViewItemQQcategoryZ33581QQihZ013QQi temZ230292320076QQrdZ1QQsspagenameZWDVW

And here are the front adjustables, I haven't used them but if they are built as well as the rears you won't be disappointed.

http://cgi.ebay.com/ebaymotors/SPC-FRONT-CAMBER-KIT-86-87-88-89-HONDA-ACCORD_W0QQcmdZViewItemQQcategoryZ33581QQihZ015QQi temZ250296463840QQrdZ1QQsspagenameZWDVW

[greentee76]

Thanks for the vouch on those. I have a nearly new set of OEM rear UCA's so I'll be using those. I saw these on the bay though and was intrigued by the adjustable fronts as some here need those.

[Pico]

Good info. Is the price on the rear arms each or pair ?

[EricW]

I like the design on the front. It looks similar to the ingalls kits (which are now discontinued) but it won't have the problem of the nut striping since the bolt is fully threaded and doesn't have a flat spot down one side of it.

[nswst8]

Its per pair, this is actually $10 cheaper than what I paid acouple of years ago.

[LX-incredible]

I bought a set a while ago. Surprised me that they were made in china. The quality of the arms seem better than the ingalls, but the ball joint looks kind of cheap. Probably be fine and you could always press a quality joint in later. I have been making it a point not to replace important parts with chinese bullshit, but what can you do?

[nswst8]

Wow, if this was made in China its one of the first times I've seen something this heavy duty. And if the ball joint fails then I'd just swap it out. Probably with something like MOOG.

[thegreatdane]

Thanks for the vouch on those.

x2

[LX-incredible]

Wow, if this was made in China its one of the first times I've seen something this heavy duty. And if the ball joint fails then I'd just swap it out. Probably with something like MOOG.

Exactly what I thought when I pulled them out of the box.

[Oldblueaccord]

http://www.3geez.com/forum/showthread.php?t=63821

That rubber washers on the front kit is junk it wont last 6 months.

Pretty sure the Ingalls rear arms are still available at livermore racing.



wp

[ChaseR]

I have SPC Camber kits on my 07 Si and have not had one bit of problem with them, I Don't see why SPC would slack on the 3geez quality.

[Oldblueaccord]

I think there kits are fine just on mine and I think Russinakid too maybe the little rubber washer did not last at all. As far as made in China I bought mine like 5 years ago I think but no surprises low bid gets the work.


wp

[MessyHonda]

i just got an alignment and they fixed my rear camber according to them...but i dont have adjsutable arms...il go in again and ask them to do it again since i have 30 days to get another free one.