PDA

View Full Version : need some help...



oscwrestler
02-10-2009, 12:19 PM
so my car hasnt ran since july i think and i just gave up on it but i figered just to save some money on buying a new one id come back here.
anyways, to put this the easiest way i can, it will turn over and start (sometimes) but it wont idle. ive checked the vac lines, i just dont know what could be causing the problem. anyone else with this problem?:dunno:

greentee76
02-10-2009, 12:59 PM
Did you check the line the pcv valve is in? If that line cracks it is a BIG vacuum leak.
Are you getting fuel? spark?

oscwrestler
02-10-2009, 01:02 PM
im getting fuel and spark because it'll run if i keep my foot on the gas. if i shift into drive i need to use the break as a clutch and rev the engine to keep it fromdying as well. i think that is just needing tranny fluid though.

oscwrestler
02-10-2009, 01:04 PM
and no i didnt check the pcv. where is that at?

greentee76
02-10-2009, 05:14 PM
On the intake manifold in front of the carb you will see a hose that comes up, makes a U and goes back down to the manifold. The valve itself sits in a hole on the manifold on the left side of that U. If that all looks good the hosing continues down below the manifold to a breather box on the rear of the engine.

Dr_Snooz
02-10-2009, 09:08 PM
Carb or injected?

greentee76
02-11-2009, 04:06 PM
Carb or injected?

Good question. I assumed since he was posting in carb tech that it was carbed?

oscwrestler
02-15-2009, 03:08 PM
yeah it is carbed lol.